Why We Hand Nail

GOING A STEP FURTHER

When you are choosing a roofing contractor, picture this scenario: a roofer on a steep slope, in the blazing summer sun, holding a heavy nail gun, working as quickly as he can. His goal is to hit an inch-wide nailing strip, assuring the nail will be properly driven and not crooked – every time! This does not sound very likely, right? That is why we hand nail our roofs. Given the opportunity to choose between a hand-nailed roof and a roof that could be installed incorrectly with a nail gun for the same price, why not choose peace of mind and quality?
We have taken the time to list the main issues with using nail guns to emphasize the importance of our roofing method. The problem is, most of the issues do not make an appearance until after workmanship warranty has expired, and then there is the chance of invalidating your warranty with the shingle manufacturer. Contact us today to learn more about our process or for free estimate on our next roof installation.
We proudly offer hand nailed roof in, and surrounding areas. Contact us today for more information or to schedule a free estimate!

OVER-DRIVEN NAILS

When the pressure on compressors is not set properly, roofing guns can drive nails through the shingles and indent them. This causes shingle failure and oftentimes creates a leak point all the way through the roof deck. This also tears the shingles, making them easier to blow off. This is nearly impossible with hand nailing because the hammer hits the shingle, decreasing the pressure on the nail head.

SIDE-DRIVEN NAILS

A side-driven nail leaves part of the nail head sticking up, creating several problems. The sharp edge of the nail can cut a hole in the top shingle above and tear the shingle below. This can create a hole in the top shingle and cause leaks. The nail head can also lift the single edge just enough to allow wind-blown rain to get under the shingle and cause leaks. Because a crooked nail can tear a shingle, it makes it more likely to blow off in high wind.

UNDER-DRIVEN NAILS

An under-driven nail occurs when the compressor is not set correctly and thus the nails is not set properly. This problem leads to the head of the nail cutting through the shingle above, possibly creating a hole for the leaks. This also affects the attached shingle by making it easier to blow off. If a roofer used hammers, he would have had the accuracy to set it properly.

MISSING THE NAIL STRIP

When an inexperienced or hurried roofer uses a nail gun, he can regularly miss the nail strip. This can lead to high nailing which not only affects the shingle being attached, but also causes the shingle below to be missed. The result can be shingles sliding out or being easily blown off. Nails inserted below the strip can be exposed since they are not covered by the shingle above, which is unappealing and dangerous.

"VERY IMPRESSED From start to finish so happy with the service of State Roofing Company!"

More Reviews